Operating instructions — electronic – Lennox Hearth ADAGIO-EN User Manual

Page 21

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

OFF

SIT

ELECTRONIC

GAS VALVE

HI/LO Variable

Flame Height

Adjustment

Standard Burner

OFF/ON Rocker

Switch

A. This appliance is equipped with an ignition device which

automatically lights the pilot. Do not try to light the pilot

by hand.

B. BEFORE OPERATING smell all around the appliance area

for gas. Be sure to smell next to the floor because some

gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone

in your building.

FOR YOUR SAFETY READ BEFORE OPERATING

• Immediately call your gas supplier from a neighbor’s

phone. Follow the gas supplier’s instructions.

• If you cannot reach your gas supplier, call the fire depart-

ment.

C. If any portion of this appliance does not operate as the

instructions indicate, do not try to repair it, call a qualified

service technician. Do not use tools. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of the

control system and any gas control which has been under

water.

OPERATING INSTRUCTIONS — ELECTRONIC

1. For complete shut-down, turn remote wall switch to “OFF"

or set the thermostat to the lowest setting, if applicable.

2. Turn the ON/OFF switch to “OFF”. If step 1 is not applicable.

3. Close the main line shut-off valve.

TO TURN OFF GAS TO APPLIANCE

OPERATING INSTRUCTIONS

1. STOP! Read the safety information above on this page.

2. Turn remote wall switch to “OFF" or set wall thermostat to

lowest setting, if applicable.

3. Turn the ON/OFF switch to "OFF" if step 2 is applicable,

this ON/OFF switch should always be in the "OFF" posi-

tion.

4. Verify main line shut-off valve is open.

5. This appliance is equipped with an ignition device which

automatically lights the burner. Do Not try to light the

burner by hand.

6. Wait five (5) minutes to clear out any gas. Then smell

for gas, including near the floor. If you smell gas, STOP!

Follow “B” in the safety information above (to the left) on

this label. If you don’t smell gas, go to the next step.

7. Turn "ON" all electrical power to appliance (remote wall

switch), or set the thermostat to the desired setting, if

applicable.

8. Turn the ON/OFF switch on the appli-

ance to "ON," if Step 7 is not applicable.

9. If the appliance will not operate, follow

the instructions "To Turn Off Gas To Ap-

pliance" and call your service technician

or gas supplier.

TO SHUT OFF

1. Turn off all electrical power to the appliance (remote wall

switch) or set the thermostat to the lowest setting, if ap-

plicable.

WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY

RESULT CAUSING PROPERTY DAMAGE, PERSONAL INjURY OR LOSS OF LIFE.