Lennox Hearth ADAGIO-EN - Manual (Page 10)

10
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Front Glass Enclosure Panel, Removal
and Installation
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass door by
striking or slamming shut.
An firebox liner kit (sold separately) must be
installed prior to installing the glass door. Install
the liner per instructions provided in kit.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panel is installed. Generally the front
glass enclosure panel should not be removed
except to gain access to the components within
the firebox.
During this appliance checkout and adjust-
ment period, a potential safety hazard exists
- EXERCISE EXTREME CAUTION to prevent
the occurrence of any burn injuries from the
exposed flames or hot surfaces.
Removing Glass Enclosure Panel
(see Figures 4 and 5)
1. Remove the facade assembly by lifting it
up and toward you (see the installation
instruction sheet provided with the facade
for additional information).
2. Locate the two (2) latches at the top of the
control compartment (see Figure 4). To
disengage the two latches, pull the spring-
loaded latches forward then down as shown
in Figure 4.
3. Swing the bottom of the door out (see Figure
5) and raise it slightly to lift the top flange of
the door frame away from the appliance.
Installing Glass Enclosure Panels
(see Figures 4 and 5)
Note: This appliance is not approved for opera-
tion without a log set (provided) or a firebox
liner kit installed (sold separately).
1. Visually inspect the gasket on the backside
of the glass panel. The gasket surface must
be clean, free of irregularities and seated
firmly.
IMPORTANT NOTE: Be very careful not to
damage the refractory firebox liner when
installing the door. Take care when seat-
ing the top door gasket so that it is not
obstructed by the refractory panel. If the
door feels restricted when latching, the top
door gasket may not be properly seated.
Figure 5 - Glass Door Removal
Door
Assembly
Figure 4 - Glass Door Latches
Spring-Loaded Latches
Pull forward then down to release
Pull Latches
Forward
WARNING
• Do not attempt to substitute the
materials used on this door,
or replace cracked or broken
glass.
• Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
• The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
• Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is in
use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
2. Position the glass enclosure panel in front
of the firebox opening at a 45 degree angle
and engage the top flange over the lip at the
top of the firebox opening (read important
note above) (see Figure 5).
3. Swing the glass enclosure panel down and
back. Ensure the gasket seats evenly as
the panel draws shut. Close the latches to
secure the panel.
4. Reinstall the facade assembly.