Life Fitness Treadmill - Manual (Page 15)

P
OWER
C
ORD
R
OUTING
The power cord can be run straight from the treadmill, shortened and exited out the user-front
left side, or run under the frame and exited out the user right-rear side of the treadmill.
For efficient cord management, the following routing options are recommended:
With the power cord unplugged, insert the clips in the appropriate holes. See the illustration
below. Use Hole Pattern 1 or 2 to locate the clips and secure the power cord with the clips,
taking up any slack between clips.
NOTE: It may be necessary to tip the treadmill to route the power cord properly.
To plug the power cord into an outlet in front of the treadmill, use Hole Pattern 1 for outlets
located at the front of the machine.
To plug the power cord into an outlet in rear of the treadmill, use Hole Pattern 2 for outlets
located at the rear of the machine.
Make sure that there is a 6-foot clearance behind the treadmill. Contact Life Fitness Customer
Service for a longer power cord if necessary.
WARNING: Insure that the power cord (A) does not contact the striding belt or
get pinched between the frame (C), lift arm (B) or the wheel; failure to follow this
warning may result in serious injury.
AVERTISSEMENT : assurez-vous que le cordon d'alimentation n'entre pas en
contact avec le tapis et ne soit pas pincé entre le cadre, le bras de levage ou
la roue. Le non respect de cet avertissement peut provoquer de graves blessures.
NOTE: When using Pattern 1, it is extremely important to route the power cord BETWEEN the
lift frame and the main frame.
15