Linksys WPS54GU2 - Manual (Page 15)

8 Chapter 4: Configuring the PrintServer Using the Setup Wizard
Installation
Wireless-G PrintServer for USB 2.0
6. The IP Settings screen, Figure 4-5, will appear. If your network uses a router with a DHCP setting that
automatically assigns IP addresses, select Automatically obtain an IP address (DHCP). If your network
uses a static IP address, select Set IP configuration manually, and enter the IP Address, Subnet Mask, and
Gateway in the fields provided. Click Next.
Click Back to return to the previous screen.
7. The Set PrintServer’s Password screen, shown in Figure 4-6 will appear. If you want to change your
password, enter your current password in the Current Password field. Enter the new password in the New
Password field, then enter it again in the Verify Password field. Click Next.
Click Back to return to the previous screen.
Figure 4-6: Set PrintServer’s Password
Figure 4-5: IP Settings
Static IP address: a fixed address assigned to
a computer or device connected to a network.