Linksys WPS54GU2 - Manual (Page 11)

4 Chapter 2: Getting to Know the PrintServer
The Front Panel
Wireless-G PrintServer for USB 2.0
The Front Panel
The PrintServer’s LEDs are located on the front panel.
Status Green/Orange. If the Status LED is continuously lit green, then the PrintServer is ready for use.
The LED flashes green when the PrintServer is booting up, a system self-test is running, or the
firmware is being upgraded. It lights up orange when there is an error.
LAN Green/Orange. If the LAN LED is continuously lit green, the PrintServer is successfully
connected to a device through the LAN port. The LED flashes green when the PrintServer is
actively sending or receiving data from the wired network. It flashes orange when there are
collisions detected on the LAN port.
WLAN Green. The WLAN LED serves two purposes. If the LED is continuously lit, the PrintServer is
successfully connected to the wireless network. If the LED is flashing, the PrintServer is
actively sending or receiving data from the wireless network.
Parallel Green/Orange. The Parallel LED lights up green when there is a printer connected to the
parallel port. The LED flashes green when the PrintServer is sending data through the parallel
port. It lights up orange when there is a problem with the parallel printer.
USB Green/Orange. The USB LED lights up green when there is a printer connected to the USB port.
The LED flashes green when the PrintServer is sending data through the USB port. It lights up
orange when there is a problem with the USB printer.
Figure 2-2: PrintServer’s Front Panel