Lincoln Electric POWER MIG 11521 - Manual (Page 10)

INSTALLATION A-2 A-2
Power MIG® 215XT
75°C Copper Wire 75°C Copper Wire
Input Ampere in Conduit in Conduit
Input Voltage/ Fuse or Breaker Rating On AWG (IEC) Sizes AWG (IEC) Sizes
Frequency (Hz) Size (Super Lag) Nameplate (For lengths (For lengths
up to 100 ft.) exceeding 100 ft.)
208/50/60 60 45A 10 (6 mm2) 8 (10 mm2)
230/50/60 60 41A 10 (6 mm2) 8 (10 mm2)
NOTE: Use #10 AWG Grounding Wire
TECHNICAL SPECIFICATIONS – POWER MIG ® 215XT
INPUT – SINGLE PHASE ONLY
RATED OUTPUT
OUTPUT
RECOMMENDED INPUT WIRE AND FUSE SIZES
Height Width Depth Weight
31.79 in 18.88 in 38.78 in 210 Ibs
808 mm 480 mm 985 mm 95 kg
PHYSICAL DIMENSIONS
Wire Speed 50 – 700 IPM (1.27 – 17.8 m/minute)
WIRE SPEED RANGE
Standard Voltage/Phase/Frequency Input Current @ 170 Amp Rated Output Input Current @ 215 Amp Rated Output
208/230/1/50/60 Hz (With 115V receptacle loaded to 15A) (With 115V receptacle loaded to 15A)
39/35 Amps 45/41 Amps
TEMPERATURE RANGES
STORAGE TEMPERATURE RANGE
-40°F to 185°F(-40°C to +40°C)
OPERATING TEMPERATURE RANGE
-4°F to 104°F(-20°C to +40°C)
Duty Cycle Amps Volts at Rated Amperes
30% 215 Amps 22 Volts
40% 190 Amps 23 Volts
60% 170 Amps 24 Volts
Welding Current Range Maximum Open Circuit Voltage Welding Voltage Range
30 – 250Amps 35 Volts 13.5-24 Volts
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC