La Crosse Technology WS-7078UF - Manual (Page 18)

18
1. The snooze function is activated by pressing any one of
the following buttons: “SET”, “IN”, “OUT” or “SNZ”.
2. To turn the alarm off completely, press any of the
following buttons: “CH”, “AL1”, “AL2” or “DATE”.
3. The snooze function will last for 5 minutes before the
alarm begins to sound again. Either the ((1)) or the ((2))
icon will flash during the snooze mode.
VI. Adding Remote Thermo/hygro Sensors (OPTIONAL)
The WS-7078UF is able to receive signals from as many as 3 different
remote thermo/hygro sensors. The remote sensor model(s) that you choose
will come with their own set of instructions, follow these instructions for a
complete guide to setting up. Following are some brief instructions for the
basic set-up of remote sensor units with the WS-7078U. These extra remote
sensors can be purchased through the same dealer as this indoor weather
station or by contacting La Crosse Technology directly. A TX4U will
monitor temperature and humidity, a TX3U will monitor temperature only,
and the TX3UP will monitor water or soil temperature via a probe.
Note: When setting up multiple remote sensors it is important to remove
the batteries from all existing units in operation, then to insert batteries
first into all the remote sensors. Second install batteries into the indoor
weather station. Transmission problems will arise if this is not done
correctly and if the total time for set-up exceeds 6 minutes.
A. Set-up of Multiple Units
1. It is necessary to remove the batteries from all units
currently in operation.
2. Remove the battery covers to all remote sensors.
3. Place all remote sensors in a numeric sequential order.
4. In sequential order, install batteries following the same
battery installation procedures seen in Detailed Set-Up
Guide section of this manual.
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and
operating instructions.