La Crosse Technology WS-9210U - Manual (Page 5)

5
QUICK SET-UP GUIDE
Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1. Have the indoor weather station and remote temperature sensor 3 to 5 apart.
2. Batteries should be out of both units.
3. Place the batteries into the remote temperature sensor first then into the
indoor weather station.
(All remote temperature sensors must be started before the indoor weather
station).
4. DO NOT PRESS ANY BUTTONS FOR 15 MINUTES.
In this time the indoor weather station and remote temperature sensor will start to talk to each
other and the indoor weather station will show both the indoor temperature and an outdoor
temperature. If the indoor weather station does not display both temperatures after the 15
minutes please retry the set up as stated above. After both indoor and outdoor temperatures
are displayed for 15 minutes you can place your remote temperature sensor outdoors and set
your time.
The remote temperature sensor should be placed in a dry, shaded area. The remote
temperature sensor has a range of 80 feet. Any walls that the signal will have to pass through
will reduce distance. An outdoor wall or window can have up to 30 feet of resistance and an
interior wall can have up to 20 feet of resistance depending upon the type of construction.
Your distance plus resistance should not exceed 80 ft. in a straight line.
NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be
avoided.
To complete the set up of your indoor weather station after the 15 minutes have passed please
follow the steps on pages 8 and 9.
Note: The remote temperature sensor transmits a signal every 3 minutes; after the
batteries have been installed, the indoor weather station will search for the signal
for a duration of 5 minutes. If there is no temperature reading in the OUTDOOR
LCD after 5 minutes, make sure the units are within range of each other or repeat
the battery installation procedure.