La Crosse Technology WS-9210U - Manual (Page 16)

16
the “OUT” button for 5 seconds, the records for the selected remote
temperature sensor unit will be reset.
MOUNTING
Note: Before permanently mounting ensure that the indoor weather station is able
to receive WWVB signals from the desired location. Also, extreme and sudden
changes in temperature will decrease the accuracy of the indoor weather station
and changes in elevation will result with inaccurate weather forecasting for the next
12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining
reliable data. To achieve a true temperature reading, avoid mounting where direct
sunlight can reach the remote temperature sensor. We recommend that you mount
the remote temperature sensor on a North-facing wall. The sending range is 80ft—
obstacles such as walls, concrete and large metal objects can reduce the range.
Place both units in their desired location and wait approximately 15 minutes before
permanently mounting to ensure that there is proper reception. The indoor weather
station should display a temperature in the OUTDOOR LCD within 4 minutes of
setting up.
I. THE REMOTE TEMPERATURE SENSOR
The remote temperature sensor can be mounted in two ways:
• with the use of screws, or
• using the adhesive tape.
A. MOUNTING WITH SCREWS
1) Remove the mounting bracket from the remote temperature
sensor.
2) Place the mounting bracket over the desired location.
Through the three screw holes of the bracket, mark the
mounting surface with a pencil.
3) Where marked, start the screw holes into mounting surface.
4) Screw mounting bracket onto the mounting surface.
Ensure that the screws are flush with the bracket.
B. MOUNTING WITH ADHESIVE TAPE
1) With a nonabrasive solution, clean and dry the back of the
mounting bracket and the mounting surface to ensure a
secure hold. The mounting surface should be smooth and
flat.