Lenoxx Electronics PH-543 - Manual (Page 8)

IB-PH543(168F)-WM-E-051203
Before you connect the phone cords, follow these steps to install
the batteries:
1. Push down the battery door tab with a pen or other pointed
object and lift the battery door out (Fig. 1).
2. Insert 3 size “AA” alkaline batteries as shown inside the
battery compartment (Fig. 2). (The negative side (–) of the
battery touches the battery spring.)
3. Replace the battery door and snap it shut (Fig. 3).
•
When the batteries are dead, the display will not show
anything. You can still make or receive calls, but you can’t use
the Caller ID functions.
•
When the batteries are dead, your call data and memories could
be erased.
Fig. 1 Fig. 2 Fig. 3
Step 1
Step 2
GETTING STARTED
Step 2: Telephone Installation
INSTALLING BATTERIES
CONNECTING THE TELEPHONE
1. Connect the COILED HANDSET
CORD to the bottom of the handset
and the bottom of the base (Step 1).
2. Connect the straight telephone line
cord to the LINE CORD jack and
telephone outlet on the wall (step 2).
(If you want to mount the telephone
on the wall, refer to Wall Mounting
instruction of this booklet)
3. Route the LINE CORD into the
channel on the bottom of the base.
If your telephone outlet is not modular, contact your telephone
company for assistance.
6
CAUTION
Make sure that the telephone line cord is disconnected before
opening the battery door.
Replace the batteries when the LOW BATTERY INDICATOR
appears in the display or when the display gets dim.