Lenoxx Electronics PH-543 - Manual (Page 17)

IB-PH543(168F)-WM-E-051203
NOTE:
1. If problems with your telephone service occur later, try to
determine if the trouble is with the telephones you own or with
the telephone company equipment. Unplug the telephone and
try it on another jack in a different room or in a neighbor’s home
to see if the phone line or the set is bad. If the known working
phone does not operate properly on that line, contact your local
telephone company for assistance.
2. If disconnection of your phone ends the problem, your phone
may be the source of the trouble and it should be tested and
repaired if necessary before it is reconnected.
3. There are no user maintainable parts or adjustments on this
set. Should your phone require repairing, contact the
manufacturer for instructions (except for cords which you can
buy at any phone store).
TROUBLE SHOOTING (continued)
PROBLEMS CHECK
Pick up the phone before the second ring,
or your phone received no information or
unclear information. Static can cause this
message. If this condition persists, contact
your local telephone company to ensure
there is no problem with your phone line.
Shows in the
display
Cannot erase
all records in
memory
The DELETE button must be quickly pressed
twice to erase a single call record. To erase
ALL call records, display any record using the
UP or DOWN button, then press and hold the
DELETE button for about 6 seconds
after you viewed all new calls.
Your language is set for French or Spanish.
To reset the language, press and hold the
DELETE button and then press the DOWN
button. While “ ” is flashing, press the
DELETE button to confirm. The language will
be set to English mode.
Caller ID dis-
plays words like
or
or
or
or
Memory Dialing
does not work
Check if you have stored the numbers
correctly by pressing that memory location
button(s). Also numbers can only be stored
when fresh batteries are installed.
The caller may have a blocked number to
prevent Caller ID identification, or it may be
an overseas call or you may have noise on
the line during that call.
Caller’s number
is not registered
to the Caller ID
memory
Check with your telephone company if this
service is available and if you have
subscribed for it.
Message Wait-
ing does not
work
The MEMORY button has no stored number.
Please store the number again. Press the
STORE button, dial the number and then
press the MEMORY locations.
Pressing a
MEMORY button
not display
stored number
15