Lincoln Electric LN-15 WIRE FEEDER SVM166-A - Manual (Page 47)

LN-15
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Section TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
Retur
n to Master TOC
RESOLUTION DESCRIPTION/
DEFINITION
0081
0082
0086
Average motor over cur-
rent shutdown
Locked rotor condition
on the wire drive motor.
Trigger lockout.
TROUBLESHOOTING & REPAIR F-9 F-9
FAULT CODES
NOTE: If more than one fault message is being displayed, perform all the checks for the faults
before replacing the printed circuit board
• The wire drive motor has overheated.
• Check to make sure the electrode
slides easily through the liner of the
gun.
• Reduce the spindle brake resistance.
• Reduce the amount of tension in the
wire drive tension arm.
• For the best results, use only Lincoln
electrodes.
• Wait 10 minutes for the wire feeder to
cool.
• Verify that nothing is jammed in the
wire drive or gears.
• The ripple of the power source OCV
is too high, greater than 110V.
(Across the Arc Models only)
• Verify that the power source is
reconnected for the proper input
voltage.
• Repair or replace the power source.
The power source does not conform
to NEMA.