Permanent connection, Evacuation functions – LST BC06-2 User Manual

Page 3

BC06_DBL_LST_EN_0826.PDF • PAGE 3

Building Safety. Building Security.

Permanent Connection

A variety of peripheral devices can be connected to the

Fire Detection Control Panel Series BC06:

• Acoustic and optical signalling devices

• Fire controls

• External protocol printer

• Transmitting devices for alarm transmission

– and much more.

Evacuation functions

In order to comply with different country-speciﬁ c require-

ments, the control panel can be equipped with an evacu-

ation function for the manual activation of the alarming

devices also without ﬁ re alarm (evacuation alarm). This

function is determined by the installer during parameteri-

sation. Two modes of operation are available therefor:

• With the „Evacuate function“ the undelayed activation

of the desired alarming device occurs by pressing the

corresponding „Alarming“ button and is indicated by a

red LED. Pressing the button once again will silence the

alarming device again, regardless of as to whether the

evacuation alarm has been triggered by a ﬁ re alarm or

manually.

• For the „Evacuation circuit / NEN 2575“, additional ope-

rating buttons for the operation of the evacuation circuit

are enabled during commissioning. An optional front foil

is used for the labelling of these buttons. This function

always acts on both alarming devices. In order to acti-

vate the alarming devices, the „Enable“ button must be

pressed in addition to the „Activate EV circuit“ button.

The alarming devices are silenced again by pressing

the „Silence EV circuit“ button. The condition of the alar-

ming devices is indicated via LEDs.