Lathem 7500E - Manual (Page 8)

Setting the Display Hours
22
5
1
Push the DATE/TIME button for 5
seconds and position the " " under
the "CLOCK OPTION" mark.
A flashing number can be changed.
2
Push the CHANGE button to select
either "1" for AM/PM or "2" for 24
hour with the left-side number.
Set the "Display Hours"
.
SET SELECT CHANGE
CLOCK
OPTION
Display
Hours
Type of Hour
AM/PM (12 hour)
24 hour
For example,
PM
2:55
For example, 14:55
1
2
3
SET SELECT CHANGE
CLOCK
OPTION
"Display Hours" is the format that the hours appear on the clock face. The default is
"AM/PM".
Push the SET button to confirm the
setting. At that moment, the flashing
of display will change to the right-side
number. The unit is set to "1" for the
Eastern Time Zone. If you need to
change the time zone for atomic clock
function, go to Setting the Time Zone
for Atomic Clock Function.
If you don't need to change the time
zone setting shown on the display,
push the SET button two more times
to finish the setting. Then, the unit
starts reception of the WWVB radio
signal.