Linksys AG241 - Manual (Page 14)

8 Chapter 3: Getting to Know the ADSL2 Gateway with 4-Port Switch
The Back Panel
ADSL2 Gateway with 4-Port Switch
Chapter 3: Getting to Know the ADSL2 Gateway with 4-
Port Switch
The Back Panel
The Gateway’s ports, where a network cable is connected, are located on the back panel. The Gateway’s buttons
are also located on the back panel.
LINE The LINE port connects to the ADSL line.
Ethernet (1-4) The Ethernet ports connect to your computer and other network devices.
Reset Button There are two ways to Reset the Gateway's factory defaults. Either press the Reset Button, for
approximately ten seconds, or restore the defaults from the Factory Defaults screen of the
Administration tab in the Gateway’s Web-Based Utility.
Power The Power port is where you will connect the power adapter.
On/Off Switch This switch is used to turn the Gateway on or off.
With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys
international website at www.linksys.com/international for more information about products that work with the
Gateway.
Important: Resetting the Gateway to factory
defaults will erase all of your settings
and replace them with the factory defaults. Do
not reset the Gateway if you want to retain
these settings.
Figure 3-1: Back Panel