Lochinvar 1.3 - Manual (Page 4)

What is in this manual?
Service
Near boiler piping
• Typical system components
The SMART TOUCH display
• Touch screen readout, buttons and their functions
Control module inputs
• Control module inputs and options
Control module outputs
• Control module outputs and options
General
• How the boiler operates
• How the control module operates
• Access modes -- user and installer
• Sequence of operation -- Hot Water Generation
(HW)/space heating
Control panel menu access
• Accessing programming mode and locating menus
(See separate guides covering the PC interface.)
Control panel parameter access
• Accessing and changing parameters from the touch screen
Quick start information -- parameter
table
• An index of available adjustments and readouts, where to
access them and where to find detailed information.
SYNC operation
• Service / Setup
• Set Points
• Outdoor Reset
• Night Setback
• Cascade
• Pumps
• BMS
Maintenance
• Service and maintenance schedules
• Address reported problems
• Inspect boiler area and boiler interior
• Clean condensate trap
• Check all piping for leaks
• Check air openings
• Flue vent system and air piping
• Check water system
• Check expansion tank
• Check boiler relief valve
• Inspect ignition electrode
• Check ignition ground wiring
• Check all boiler wiring
• Check control settings
• Perform start-up and checks
• Check burner flame
• Check flame signal
• Check flue gas temperature
• General maintenance
• Review with owner
• Cleaning boiler heat exchanger
• Oiled bearing circulators
Troubleshooting
• Troubleshooting table - No display
• Checking temperature sensors
• Sensor tables
• Troubleshooting table - Fault messages displayed on
boiler interface
• Combustion analysis procedure
• Gas valve adjustment procedure
Service Manual
4