La Crosse Technology WS-7016U - Manual (Page 3)

9
2. Observing the correct polarity,
install 2 AA batteries.
3. Replace battery cover.
4. Wait 5-6 minutes or until both
indoor and outdoor temperatures
are shown on the Indoor
Temperature Station.
5. The Indoor Temperature Station
should now show: “-:- -” in the
TIME LCD, and temperatures in
the INDOOR and OUTDOOR
LCD’s.
TIME LCD
INDOOR LCD
OUTDOOR LCD
10
II. TIME
A. SETTING THE TIME
1. Press and hold the SET button for
1 second. “12h” will appear in the
TIME LCD.
2. Use the INDOOR button to select
either 12h time or 24h time (12h is
an AM—PM mode, and 24h is
military time).
3. Press the SET button 2 times,
“TIME” will flash in the upper left
corner.
4. Press the INDOOR button to set
the hours, and press the
OUTDOOR button to set the
minutes.
Control Buttons
11
5. Press the SET button to activate
the clock.
Note: There is only a “PM” display,
which appears under “TIME.” If there
is no display here it is AM. Make sure
you set the time accordingly.
III. UNITS OF TEMERATURE MEASURE
A. SELECTING UNITS OF
MEASUREMENT
1. Press and hold the SET button for
1 second.
2. Press the SET button again. “
F”
will appear in the TIME LCD.
3. Press the INDOOR button to shift
between
F and C.
4. Press the SET button twice to
activate settings.
12
IV. FEATURES
A. INDOOR MINIMUM AND
MAXIMUM TEMPERATURES
1. Press and hold the INDOOR
button for 1 second. “MIN”
appears in the INDOOR LCD and
the recorded minimum
temperature is displayed.
2. Press and hold the INDOOR
button for 1 second. “MAX”
appears in the INDOOR LCD and
the recorded maximum
temperature is displayed.
Note: When first setting-up the
minimum and maximum temperatures
may be the same as the current
temperatures.
3. To return to the current
temperature, press and hold the
INDOOR button for 1 second.