Lenovo 3000 Y410 - Manual (Page 57)

Replacing Memory
Chapter 5. Upgrading and Replacing Devices 49
To install an SO-DIMM, do the following:
1.
Touch a metal table or a grounded metal object. This action reduces any
static electricity in your body, that could damage the SO-DIMM. Do not
touch the contact edge of the SO-DIMM.
2. Turn off the computer ; then disconnect the ac adapter and all cables
from the computer.
3. Close the computer display, and turn the computer over.
4. Remove the battery.
5. Unfasten the two screws a on the cover and remove the cover b.
6. Find the notch on the contact edge side of the SO-DIMM.
Attention: To avoid damaging the SO-DIMM, do not touch its contact edge.
7. With the notched end of the SO-DIMM toward the contact edge side of
the socket, insert the SO-DIMM into the socket at an angle of about
20 degrees, then press it in firmly a.
8. Push the SO-DIMM down until it snaps into place.
2
1
1
1
1
2
Lenovo 3000Y410 UG.book Page 49 Friday, September 14, 2007 1:37 PM