Loom routing to hour meter, Hour meter connection, Assembly instructions – Land Pride ZT60 User Manual
Page 7
7
7/18/08
Manual No. 357-178M
Assembly Instructions
Land Pride
■
Loom Routing To Hour Meter
Refer to Figure 18:
1.
Remove the two Phillip head screws (#1) securing
console panel.
2.
Lift console panel up and locate hole in bottom of
console cavity.
3.
Route end “C” of hour meter loom along right side of
the mower frame and up through hole in bottom of
console cavity.
Console Panel
Figure 18
Refer to Figure 19 & Figure 20:
4.
Pull excess loom inside of cavity (Figure 19) and
plastic tie hour meter loom to main loom inside of
cavity (Figure 20). See Important note below.
Hour Meter Connection
Refer to Figure 21:
1.
Pull gray wire female terminal from hour meter.
Locate gray wire female terminal on end “C” of the
plastic loom and attach it to the hour meter terminal.
2.
Pull black wire female terminal from hour meter.
Locate black wire female terminal on end “C” of the
plastic loom and attach it to the hour meter terminal.
3.
Connect the pulled gray and black female terminals
to the male terminals on end “C” of the plastic loom.
Be sure to attach gray to gray and black to black.
4.
Replace console panel and tighten screws.
Hour Meter
Blade
Engagement
Ignition
Switch
1
1
Choke Knob
24961
Throttle Lever
IMPORTANT: Do not tie loom to throttle cable or
choke cable. Tying to either will limit their operation.
Hour Meter Loom Placement
Figure 19
Hour Meter Loom Tie Location
Figure 20
Headlight Loom Placement
Figure 21
Hour Meter
Loom
Hole in
Console Cavity
Female Terminal
on Gray Wire
Connects to Hour
Meter
Female Terminal
on Black Wire
Connects to Hour
Meter
Male Terminal
on Gray Wire
Male Terminal
on Black Wire
24962
Plastic Tie
(Do Not Attach
To Choke or
Throttle Cables)
Throttle Cable
Main Loom
Hour Meter Loom
Choke Cable
24963
Female Terminal On Gray Wire
Connects To Positive (+)
Terminal On Hour Meter
Female Terminal On Black
Wire Connects To Negative (-)
Terminal On Hour Meter
Male Terminal On Black Wire
Connects To Black Wire
Pulled From Hour Meter
Male Terminal On Gray Wire
Connects To Gray Wire
Pulled From Hour Meter
Hour Meter Loom
24964