Liebherr WF1051 - Manual (Page 12)

A delight in freshness
WF1051 / EWTNes 2956 10
Figure 5
R
EVERSING
D
OOR
H
INGES
6. Figure 5: Unscrew the lower hinge (13).
- Remove the washer, stops and bushing (14, 7, 8).
- Remove screw (Q).
- Transfer hinge pin (2) to the opposite side.
- Transfer screw (Q) to the opposite side.
- Turn the stop (7) through 180° and position
bushing (8) and washer as shown in the
detailed drawing. The flat side of the stop must
face forwards.
- Screw on hinge (13) on the new hinge side.
7. Install the door fittings as shown in Figure 5.
Insert the plugs (X) as shown in the detailed
drawing. Move plug (W) to the opposite side of
the lower door.
8. Unscrew the center hinge (10) and cover (11),
pull them off to the side and after turning them
through 180°, slide them on again on the
opposite side and secure them.
9. Place the lower door on the hinge pin (2) at the
bottom.
- Swivel in the door.
- Pay special attention to the bushing (12) in the
center hinge (10).
- Insert the hinge pin (9).