LG SAC34026004 - Manual (Page 131)

Before you begin cloning...
• The Master TV should be connected to a good, stable signal
from an over-the-air antenna or cable service Analog channel
and connected to power. (See above.)
• Teaching and Learning is only possible between identical
model devices. (However, the LT2002 Clone programmer can
store up to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB
or other device will cause the TV, STB or other device to
operate erratically or become inoperable.
• Use an Installer’s remote to operate Learning and Teaching
menus.
• Make sure that the batteries in the Clone programmer are
fresh.
• If batteries are removed, the Clone Clock time will be lost.
• Decide if you want to set the time from the Clone program-
mer or copy the time to the Clone programmer; from a com-
patible TV which has the clock set to the current time.
• Setting the time and transferring it to the Clone or other
device is a separate procedure.
• Follow the connection diagram above to connect the Clone to
a Master TV TV display panel. After learning is complete, to
another identical TV TV display panel to “teach” it the master
setup.
• See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
QuickSet II Programmer
LT2002
®
Ferrite Core
(TDK, ZCAT
2035-0930)
ZENITH ELECTRONICS CORPORATION, LINCOLNSHIRE, ILLINOIS USA
• heartbeat power on
communications ok
• slow power on
no communications
• green battery ok
• red
battery low
Blink pattern
Color
Reset
Status
Indicator
Connect cable to
TV MPI Jack and
follow on screen
instructions
MPI
THE CLONE HAS CONTROL OF THE TV
THE CLONE IS VERSION XX
THE TV IS VERSION XX
THE SW IS REVISION XX
CLONE CLOCK = XX:XX
TV CLOCK = XX:XX
-PRESS ANY KEY TO CONTINUE.
-DISCONNECT CLONE WHEN DONE.
Antenna
or CATV
Master TV
Clone Programmer
Connections for the LT2002 Clone Programmer to Learn the TV Master TV Setup
Notes: It is assumed that the TV is connected to a signal source, the source selected is Antenna (RF) In, the
signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on
and the LT2002 Clone Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the
TV screen, see above and next page.
LT2002 Cloning Connections/Learning Setup
Warning: Do not use
LT2002 while any PPV
card is installed in TV or
clone programmer device
will be damaged.
206-4118
P A G E 2 2
G G If an analog channel is not available, tune TV to an Aux source lik AV-1 for cloning purposes.