Lenovo TS130 - Manual (Page 28)

Internal drives
Internal drives are devices that your server uses to read and store data. You can add drives to your server to
increase storage capacity and enable your server to read other types of media. Internal drives are installed in
bays. In this manual, the bays are referred to as bay 1, bay 2, and so on.
Figure 7 “Drive bay locations” on page 16 shows the locations of the drive bays.
Figure 7. Drive bay locations
The following list describes the type and size of the drive that you can install in each bay:
1 Bay 1 - Optical drive bay (with an optical drive installed on some models)
2 Bay 2 - Optical drive bay
3 Bay 3 - Card reader drive bay
4 Bay 4 - Secondary SATA hard disk drive bay
5 Bay 5 - Primary SATA hard disk drive bay (with a 3.5-inch SATA hard disk drive installed)
Server components
This topic provides information about major component locations and CRU identification. For more
information about major components, see the related topics in Chapter 4 “Locating parts, controls, and
connectors” on page 11.
To remove the server cover and gain access to the inside of the server, see “Removing the server cover”
on page 21.
For the system board components, see “Locating parts on the system board” on page 14.
16 ThinkServer TS130 Hardware Maintenance Manual