Lenoxx Electronics PH-3235 - Manual (Page 13)

IB-PH3235(MS)-WM-E-122203
No dial tone.
1. Plug disconnected from jack.
2. Jack improperly wired.
Phone is dead.
1. Damaged cord.
2. Jack improperly wired.
3. Line out of order.
1. If your other telephones are “ROTARY” type
phones, your line may be conditioned to
accept PULSE dialing only.
Move TONE/PULSE switch to PULSE position.
2. Contact your phone company to have your
line changed to TONE and PULSE service.
Static noise on line or cannot hear
calling party or calling party
cannot hear you.
Replace the coil cord. Any phone store has
these cords in different lengths.
12
1. If problems with your telephone service occur later, try to determine if the trouble is
with the telephone or with the telephone company equipment. Unplug the telephone
and try it on another jack in a different room or in a neighbour’s home to see if the
phone line is bad or the phone.
2. If disconnection of your equipment ends the problem, your telephone may be the
source of the trouble and it should be tested and repaired if necessary before it is
reconnected.
3. There are no user maintainable parts or adjustments on this set. Should your phone
require repair, contact the factory for instructions (except for cords which you can
buy at any phone store).
Feedback or squealing when using
SPEAKERPHONE or HEADSET.
Volume is too high. Reduce the VOLUME of
the SPEAKERPHONE (HEADSET).
CLEANING AND MAINTENANCE
1. Keep the phone away from bathtub, water or very high heat and humidity (keep
away from stove or radiators).
2. Avoid placing it in very hot sun.
3. Do not staple phone cord.
4. Do not, under any circumstances, disassemble the telephone without disconnecting
the cord from the telephone line first. Ringer voltages can be high and dangerous.
5. Cleaning the exterior surface of the set should be done on a regular basis. Use a
cloth slightly dampened with warm, clean water to remove excess dust and dirt. Do
not use benzine, thinner, or the like, or any abrasive powder to clean the cabinet.
Wipe it with a soft cloth. The set should be kept free of dust, moisture and vibration,
and should not be exposed to direct sunlight.
6. DO NOT USE WAXES, SOLVENTS OR DETERGENTS OF ANY KIND TO CLEAN
YOUR UNIT. These products can damage the surface of the phone. Do not allow
any liquids to get inside the case.
TROUBLE SHOOTING
RINGER switch in OFF position.
Slide the switch to the LOW or HI position.
PROBLEM LIKELY CAUSES
Can receive, but cannot make
calls.
Can make calls, but phone does
not ring.
IB-PH3235(MS)-WM-E-122203 .p65 12/27/02, 12:44 PM 13