Wall mounting – Lenoxx Electronics PH-3235 User Manual

Page 12

IB-PH3235(MS)-WM-E-122203

3. Snap WALL MOUNT ADAPTOR into bottom of phone as shown on adaptor (UP

pointing to top of phone).

4. The longer wire about 7" plugs into the rear of phone, leave the other end out showing

about 3" of wire. Plug the 3" wire into wall jack.

5. Put phone over wall plate, make sure both posts fit into slots on the back of phone. Then

push down to lock phone onto wall plate.

FOLLOW THESE INSTRUCTIONS TO MOUNT THE PHONE ON THE

WALL WITHOUT A WALL PLATE

Follow these instructions to mount the phone on the

wall without a wall plate:
1. Locate a wall stud. If it is possible to utilize a wall

stud for mounting, dry wall expanders or a similar
type fastener is recommended. Consult your local
hardware stores for details.

2. Drill 2 holes 3 15/16" (100 mm) apart.

3. Put a screw into each hole and leave 3/16" (5mm)

of the head exposed to mount the phone (screws
are not included).

4. Connect the straight cord to the phone and jack.
5. Place the TELEPHONE BASE on the 2 mounting

screws and gently push down to lock into place.

WALL MOUNTING

FOR WALL USE PUT

ADAPTOR HERE

Make sure space

between holes is

Drill one hole

100 mm

IB-PH3235(MS)-WM-E-122203 .p65

12/27/02, 12:44 PM