Kenwood AMPLIFIER/TUNER R-K1000 - Manual (Page 62)

62 R-K1000
Messages
Displayed Message Meaning
CAN’T SETUP The ROOM EQ microphone is not connected.
RConnect the ROOM EQ microphone. (P.10)
Headphones are plugged into the [PHONES] jack.
RUnplug the headphones. z
z
Non-PCM The [CD IN (COAX)], [DIGITAL IN 1 (OPT)], [DIGITAL IN 2 (OPT)] or [DIGITAL IN 3
(COAX)] terminal is receiving non-PCM input singnals. (P.14–16)
R.EQ ERROR1 Measurement failed because the room being measured is too noisy.
RReduce the amount of ambient noise.
R.EQ ERROR2 Measurement failed because there is no signal input to the microphone.
UNLOCK The component connected to the [CD IN (COAX)], [DIGITAL IN 1 (OPT)], [DIGITAL IN
2 (OPT)] or [DIGITAL IN 3 (COAX)] terminal is not turned on. Alternatively, there is
no signal input. (P.14–16)
––– kHz The sampling frequency of the input PCM signals is outside the playable range.