Kathrein UFS 702sw - Manual (Page 53)

53
Audio settings
Setting the volume
Set the required volume level using the % buttons on the
remote control of the receiver. A bar indicator is displayed
on the screen to show the set volume.
Muting
Press the button to mute the sound. “Mute” is
displayed.
Press the button again to restore the sound.
Always follow the
operating instructions
for your Dolby Digital
system.
Digital output
The receiver has an audio output for AC3 format (Dolby
Digital). This gives you the opportunity to bring cinema
quality sound into your living room. Connect the digital
audio output only to an appropriate system.
Only a few programme providers broadcast the AC3 format.
If no AC3 signal is received, you can only make the normal
stereo or mono settings and choose the languages that are
broadcast.
Digital/analogue – audio mode
In digital satellite technology the picture and sound are
generally transmitted in digital format (MPEG-coded).
Where the term “Analogue audio mode” is used in this
section, it signifi es that the digital signals are converted in
the unit into audio signals and made available at the “Left”
and “Right” cinch sockets and at the TV and VCR Scart
sockets in analogue format.
By contrast, in “Digital audio mode” the signals are
transmitted in digital format via the “Digital” cinch socket to
corresponding terminal devices, such as a Dolby Surround
system, for decoding. Two-channel stereo signals (encoded