KORG Personal Multi-Effect Processor PX5D - Manual (Page 14)

14
Adjust the master level setting to change the volume of
the audio signal that’s sent from the PX5D’s OUTPUT
jack (
☞p.16 “Master level”).
Adjust the Utility mode “USBSEND” setting to change
the volume of the audio signal that’s sent from the
PX5D
’s USB connector to the computer ( ☞p.35 “USB-
SEND”).
Adjust the Utility mode “USB RCV” setting to change
the volume of the audio signal that’s input from the com-
puter to the PX5D (
☞p.35 “USB RCV”).
Normally, the signal that’s being input from the AUX
jack is not sent to the USB connector. If you want the
input signal from the AUX jack to be sent to your com-
puter, access the Utility mode “AUX > USB” screen
(
☞p.35 “AUX>USB”).
If you’re recording the PX5D’s effect output onto an au-
dio track of your DAW software, turn off the “audio in
thru” function of your software to prevent echo-back.
For details on using your DAW software, refer to the op-
eration manual included with your software.