KORG Kaptivator KTV1 - Manual (Page 19)

17
Owner’
s Manual
5. Using Motion Sequences
You can record and save up to one hundred sets of controller movements as “motion se-
quences,” and then select a motion sequence and play it back when desired. In addition to
movements of the various controllers and operations on the clip pads, a motion sequence
can also include bank or style selections and changes.
Playing a motion sequence
1 To enter Motion Sequence mode, press the MOTION key; the MOTION key will blink. Press
the blinking MOTION key to exit Motion Sequence mode.
2 Use the VALUE knob to change the motion sequence number “-**-” shown in the VALUE
display. If the “-” at both sides is blinking, this indicates an empty motion sequence that has
not yet been recorded.
3 Press the YES/WRITE key to confirm your selection.
4 Press the
key to playback the motion sequence. Press the key once again to pause.
5 Press the STOP key to stop the motion sequence.
If you’ve assigned the motion to once, playback will end automatically.
6 Press the blinking MOTION key to exit Motion Sequence mode. You can’t exit Motion Se-
quence mode unless the motion sequence is stopped.
Looping the playback of a motion sequence
1 When the MOTION key is blinking, hold down the EDIT key and press the MOTION key;
the EDIT key and MOTION key will blink.
2 Use the VALUE knob to make the VALUE display read “LOOP.” Choose “ONCE” if you
don’t want the motion sequence to loop.
Play repeatedly Play once
3 Press the YES/WRITE key twice to confirm the setting.
Recording a motion sequence
1 If the MOTION key is blinking, you are already in Motion Sequence mode. To enter Motion
Sequence mode, press the MOTION key; the MOTION key will blink. Press the blinking
MOTION key to exit Motion Sequence mode.
2 Use the VALUE knob to change the motion sequence number “-**-” shown in the VALUE
display.
If the “-” at both sides is blinking, this indicates an empty motion sequence that has not yet
been recorded. Choose a motion sequence number that has not yet been recorded, and press
the YES/WRITE key.
NOTE If none of the motion sequences are empty, you’ll need to erase one. (
☞
p.18: Erasing a mo-
tion sequence)
3 Press the REC key to enter standby mode. (The REC key will blink.)
4 Recording will begin when you perform an operation that can be recorded as a motion se-
quence.
5 Press the STOP key to stop recording the motion sequence.