Kenwood DPF-2010 - Manual (Page 6)

6
DPF-3010/2010/1010 (En)
System connections
Caution:
Do not plug in the power lead until all connections are com-
pleted.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to “In case of difficulty”.
™
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm Rear panel: 10 cm
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Notes Notes
Commercially-available
optical fiber cable
SL 16/XS8 switch
8
System control cord
Audio cord
Amplifier
Remove the
protection cap
when using the
DIGITAL OUTPUT
(OPTICAL) jack.
To wall AC outlet
To AC outlet
ƒ
SL 16 XS-8
OUTPUT
OPTICAL
DIGITAL
OUTPUT
SYSTEM CONTROL
L
R
SYSTEM
CONTROL
L
R
CD
DIGITAL
INPUT
OPTICAL
To AC outlet
MD recorder
DIGITAL OUTPUT jack
(DPF-3010/DPF-2010 only)