Configuring interfaces, Parallel interface, Parallel interface -13 – Kyocera FS1750 User Manual
Page 58: 13 2.4. configuring interfaces
2.4. Configuring Interfaces
2-13
2.4.
Configuring Interfaces
The printer is equipped with both a parallel and serial interface. Independent settings can be made for each
interface. Optional interface can also be installed.
To configure each interface, press the
MODE key and use the + or – key to select the interface you wish to make
settings for.
☛
This interface selection does not select which interface data will be received from. The printer auto-
matically selects that interface.
Parallel Interface
The parallel interface mode of this printer supports a bi-directional/high-speed mode. Normally, this inter-
face is used under the default setting
ý$XWR, see Appendix C. After setting the interface, be sure to reset the
printer or turn the power off at least once. The new setting will be enabled thereafter.