Kenwood DP-4090 - Manual (Page 15)

15
DP-5090/4090 (En)
÷ When a track No. is selected, the track will be added to the end of the
existing program.
Press to clear tracks from the end.
To clear all track.
To check or change the programmed tracks
To add a track to the program
To clear tracks from the program
1
Press the CHECK key.
Press until the track No. to
be changed is displayed.
2
Select the new track No.
÷ Press it while the “PGM 01” indicator blinks.
÷ The track being played cannot be changed.
Auto space function
During programming of tracks, a non-recorded space of a few
seconds will be automatically created between tracks. By re-
cording tracks with these spaces on tape, the search and repeat
play operations of tape using the DPSS function (which works
by searching the non-recorded spaces) can be performed reli-
ably.
÷ Even when the performances of two tracks are continuous (which
occurs with classical or live recording music), the spaces will be
created if they have different track Nos.
REMOTE CONTROL UNIT RC-P0505
REMOTE CONTROL UNIT RC-P0505
REMOTE CONTROL UNIT RC-P0505
REMOTE CONTROL UNIT RC-P0505
P.MODE
CLEAR
÷ Perform only step 1 to simply check the program.
÷ In the case of a CD-TEXT disc, the track’s title is scrolled on the display.
÷ Each time the key is pressed, the program No. and the track No. on CD
are displayed.
G P 0 M 1 N T . O 5 2
Blinks.
Example
↓
÷ Each time the key is pressed, the last track in the program is cleared.
÷ The tracks which are programmed earlier than the track being played
cannot be cleared.
÷ Selected tracks can be also completely cleared just by operating the 0
key.
÷ The entire program is cleared.
REMOTE CONTROL UNIT RC-P0505
CHECK
1 2 3
4 5 6
7 8 9
0 +10
3
Set the entry.
P.MODE
REMOTE CONTROL UNIT RC-P0505
1 2 3
4 5 6
7 8 9
0 +10
1
Select the desired track No.
2
Press the P.MODE key.
Remote control unit only
Remote control unit only
Remote control unit only