Maintenance work on chassis and engine – KTM 950 SUPERMOTO R User Manual
Page 62
61
Bleeding the cooling system
To completely bleed the cooling system, the motorcycle must be raised approx. 50 cm
(20 in) in the front.
Remove the radiator cap
[1] and bleeder screw [2].
Completely fill the radiator with cooling liquid. Mount the radiator cap and move the motor-
cycle into a horizontal position again. Fill the compensating tank with cooling liquid until it
reaches a level between the MIN and MAX mark. Close the compensating tank.
2
Add cooling liquid until it runs out of the vent holes without bubbles and immediately mount
the screw to prevent air from entering the radiator.
1
MAINTENANCE WORK ON CHASSIS AND ENGINE
»
See also other documents in the category KTM Motorcycles:
- 125 SX (48 pages)
- EXC-F 400 XC-W (68 pages)
- 400 EXC RACING (66 pages)
- 530 XCR-W USA (125 pages)
- Supermoto 40LC4-E (46 pages)
- 380SX (153 pages)
- 1190 RC8 JP (234 pages)
- 640 LC4 (50 pages)
- 990 SUPER DUKE R (92 pages)
- 990 SUPER DUKE (90 pages)
- 50 SX PRO JUNIOR LC (35 pages)
- 125 SX (46 pages)
- EXC 200 EXC (70 pages)
- 690 ENDURO AUS/UK (179 pages)
- 400 (46 pages)
- XC 105 SX (42 pages)
- SUPERENDURO R 950 (40 pages)
- 990 ADVENTURE (102 pages)
- 200 (67 pages)
- 560 SMR 2006 (28 pages)
- 50 SX (42 pages)
- 85 SX (40 pages)
- 250 SX-F (70 pages)
- Super Duke 990s (52 pages)
- 525 SX (62 pages)
- 3CF6001G6EN (24 pages)
- 950 R (86 pages)
- Supermoto 640LC4 (46 pages)
- ENDURO 640 LC4 (60 pages)
- 85SX (42 pages)
- ENDURO SUPERMOTO 640 LC4 (60 pages)
- Supermoto 690 (165 pages)
- 950 SUPERMOTO (90 pages)
- 950 (86 pages)
- 300SX (56 pages)
- Supermoto 640 LC4 (40 pages)
- 3CF8403H0EN (28 pages)
- 50 SX JUNIOR (42 pages)
- 450 SMR (91 pages)
- 85/105 SX (42 pages)
- 3CF6001F5EN (20 pages)
- 300 XC 2008 (74 pages)
- XCF-W 250 EXC-F EN (63 pages)
- EXC 250 XC DE (69 pages)