Kenwood TK-8150 - Manual (Page 13)

9
TRUNKING ZONES
P
LACING A
D
ISPATCH
C
ALL
1 Select the desired trunking zone and a group ID.
2 Press and hold the PTT switch.
3 If the “Clear to Talk” tone sounds, communication is possible; start speaking
into the microphone. Release the PTT switch to receive.
• For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 ~ 4 cm) from your mouth.
4 When your conversation is finished, return the microphone to its hanger.
R
ECEIVING A
D
ISPATCH
C
ALL
1 When a dispatch call is received, the transceiver will automatically change to
the correct channel and you will hear the call.
2 Readjust the volume as necessary.
P
LACING A
T
ELEPHONE
C
ALL
Note: You can only make a telephone call if the telephone service is available and you have an optional
keypad microphone. Refer to “DTMF CALLS” on page 12. Consult your dealer for further details.
1 Select the desired trunking zone and a group ID.
2 Press and hold the PTT switch for approximately 1 second to ensure a
connection.
• Confirm that there is a dial tone after releasing the PTT switch.
3 Dial using the microphone keypad.
• After dialling, wait for a response from the called party.
4 When the called party responds, press and hold the PTT switch and speak
into the microphone. Release the PTT switch to receive.
• Only one person can speak at a time.
5 To end the call, press the # key or the key programmed as TEL Disconnect.
R
ECEIVING A
T
ELEPHONE
C
ALL
1 When a telephone call is received, the transceiver will automatically change to
the correct channel and you will hear the call.
2 To respond to the call, press and hold the PTT switch and speak into the
microphone. Release the PTT switch to receive.
• Only one person can speak at a time.
3 To end the call, press the # key or the key programmed as TEL Disconnect.