Kodak 777 User Manual
Page 18
18
Service
: to use these features, highlight them and press Select.
Factory Reset
: restores all settings (except Lamp Hours) to their default
after displaying a confirmation dialog box.
Lamp Reset
: resets the lamp hour counter in the About menu to zero. Do
this only after changing the lamp. It displays a confirmation dialog box.
Test Pattern
: displays a test pattern when the Blank button on the remote is
pressed. To select the patterns, use the up/down arrows on the remote.
Press the remote’s Blank button to exit test pattern mode.
Blue Only
: turns off the Red and Green portions of the input, allowing you
to properly adjust the color balance with a SMPTE color bar pattern.
ADC Calibration
: allows adjustment of the calibrated ADC values so that
color accuracy can be optimized. Adjust the slidebars for each value and
note the change in the appropriate color. Use a component input when
adjusting the Component controls.
Service Code
: only used by authorized service personnel.
Service menu
ADC calibration