Kambrook Stick Mix KSB7 - Manual (Page 10)

9
IMPORTANT: It is
advisable to use the
stick mix in short bursts,
‘pulse’ action. Do
not use the stick mix
continuously for more
than one minute. If
used for a continual
minute, allow the unit
to cool down for
5 minutes before
resuming operation.
Dislodging Food From The
Mixing Blade
Release the speed control switch.
Switch off at the power outlet and
then unplug.
Use a spatula to carefully dislodge the
food. Do not use fingers as the blades
are sharp.
After the food has been removed,
plug the unit back into the power
supply and then turn the power on
and continue processing.
Recommendations For The
Stick Mix
The Kambrook Stick Mix processes
quickly, therefore it is easy to over
process food. Remember to stop the
Stick Mix and check food regularly.
Always remove saucepan from
heat and allow to cool to room
temperature before blending.
When pureeing and blending, cut
food into uniform sizes, this will ensure
even and consistent results.
Hard food stuffs such as coffee beans,
ice cubes, cereals and chocolate in
lumps should not be processed with
this appliance, as these may damage
the blades.
To reduce spills, always use the
Blending Jug less than ½ full or
process small quantities at a time.
Using The Chopper
Attachment
Remove any packaging and
promotional labels before first use.
Remove and wash chopping blade
and chopper bowl in warm soapy
water, rinse and dry thoroughly.
CAUTION: The chopping
blade is extremely sharp;
handle only by the upper
plastic section.
To Attach The Chopper Bowl
Remove Blending Shaft from the
motor unit.
The chopping blade is extremely
sharp and you should grip it only by
the upper plastic section. Place the
blade on the drive shaft inside the
chopper bowl (Fig 4).
Fig. 4
Place the foodstuff inside the chopper
bowl no higher than halfway.