KORG MICROX X50 - Manual (Page 56)

49
C
OMBI
0
1
2
3
4
5
6
7
8
9
( ☞p.25 PROG 7: Ed–Arp/Ctrls)
* These parameters can also be set in “0–4: Arp. A, 0–5: Arp.
B”
7–2(3)b: (Tempo)
(Tempo) [040...240, EXT]
Sets the tempo of the arpeggiator. This can be adjusted by
the REALTIME CONTROLS C-mode [TEMPO] knob.
☞p.34 “ (Tempo)” (0–1a)
■ 7–2(3): UTILITY
☞“Write Combination,” “Solo Selected Timbre” (0–1),
“Copy Arpeggiator” (7–1)
7–4: Zone
(Scan Zone)
These settings specify the note and velocity ranges that will
operate arpeggiators A and B.
7–4a: Scan Zone A/B
Zone Map
This shows the “Scan Zone” for each arpeggiator, A and B.
A: Key
Btm (A-Bottom Key) [C–1...G9]
Top (A-Top Key) [C–1...G9]
Specifies the range of notes (keys) that will operate
arpeggiator A. “Top” specifies the upper limit, and “Btm”
specifies the lower limit.
A: Vel (Velocity)
Btm (A-Bottom Velocity) [001...127]
Top (A-Top Velocity) [001...127]
Specifies the range of velocities that will operate arpeggiator
A. “Top” specifies the upper limit, and “Btm” specifies the
lower limit.
B: Key
Btm (B-Bottom Key) [C–1...G9]
Top (B-Top Key) [C–1...G9]
B: Vel (Velocity)
Btm (B-Bottom Velocity) [001...127]
Top (B-Top Velocity) [001...127]
Specify the range of notes (keys) and velocities that will
operate arpeggiator B (
☞“A: Key,” “A: Vel”).
X50: The values of these parameters can also be entered by
playing a note on the keyboard while you hold down the
[ENTER] button.
■ 7–4: UTILITY
☞“Write Combination,” “Solo Selected Timbre” (0–1),
“Copy Arpeggiator” (7–1)
7–4a
Key zone of arpeggiator A
Velocity zone of
arpeggiator A Velocity zone of
arpeggiator B
Key zone of arpeggiator B
C–1–G9