Kenwood DPX-4020 - Manual (Page 8)

— 8 —
English
General features
Switching Modes:
Each time you press the SRC (source) button, the mode
switches as follows:
Selecting standby mode:
Press the SRC button repeatedly and switch to "ALL OFF" .
When "ALL OFF" is displayed, the standby mode is activated.
The standby mode turns all functions off while leaving the
power to the unit on. Use this mode when you want to have
the display illuminated but don't want to listen to anything.
• The mode switches to the next mode from any mode which
cannot be used.
• The external disc control mode will differ depending on the unit
that is connected.
• To enable the selection of External disc control mode 2/AUX
mode, you should connect optional switching adapter KCA-
S210A (which allows you to select both External disc control
mode 2 and AUX mode) or CD changer (KDC-CPS89, KDC-
CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or
KDC-CX82) or switching adapter CA-C1AX (which allows you to
select AUX mode only).
NOTE
▼
Tuner mode
▼
CD mode
▼
External disc control mode 1
▼
External disc control mode 2/AUX mode
Tape mode
▼
▼
Standby mode
Switching Modes
Adjust various parameters of sound quality.
Audio Control Setting
Press the AUD button for at least one second to enter the
control mode.
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
Adjust each mode
Press the
4/¢ button.
Look at the table to adjust the mode being displayed.
Press the AUD to end the control mode.
• Non-Fading :
This mode is available only when the non-fading output function
is set to on.
• Refer to the catalog or instruction manual for power amplifiers
that can be controlled from this unit.
NOTE
4
Adjustment
mode
(Display)
Balance
("Balance")
Fader
("Fader")
4 button ¢ button
Operation of Audio control button
Front channel increased. Rear channel increased.
Non-Fading
("NON FAD") The non-fading output
off.
"Off" : Bass boost level is flat. (Default setting)
"1" : Bass boost level is low (+6dB).
"2" : Bass boost level is high (+12dB).
The non-fading output
on.
External Amp
Control
("Amp CTRL")
Right channel emphasized. Left channel emphasized.
3
Balance
Fader NON FAD
Amp CTRL
2
1
DPX-5050_M_r1_U.S 03.1.21 0:00 PM Page 8