Kenwood KDC-MP443U - Manual (Page 18)

18 | KDC-MP5043U/ KDC-MP543U/ KDC-MP443U
P.CONT
ANT.
CONT
MUTE
Connecting Wires to Terminals
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
To Kenwood disc changer/ External optional accessory
(KDC-MP5043U/ MP543U only)
⁄
To connect these leads, refer to the relevant instruction manuals.
TEL mute wire (Brown)
Connect to the terminal that is grounded when either the telephone rings
or during conversation.
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
Power control wire (Blue/White) When using the optional power amplifier, connect to its power control
terminal.
AUX input (Stereo)
Use the mini-plug cable which is stereo
type and does not have any resistance.
USB connector
Front output
(KDC-MP5043U/ MP543U only)
Rear output/ Sub Woofer output
Front side
Motor antenna control wire (Blue) Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film or short pole-type antenna.