Kenwood REMOTE PORTAL AXCESS - Manual (Page 8)

Getting to Know Your Axcess
4 How to Use and Enjoy Your Axcess Remote Portal
How Do I Turn On Axcess?
Press the POWER button on front panel or POWER ON on the remote to turn
Axcess on. Axcess is always in one of four power states:
Axcess automatically configures itself, but if it fails to do so,
follow the manual procedure. Axcess will prompt you to
manually enter the network settings (IP address, gateway
address, network mask and DNS address). Get this
State: Meaning: Action:
Power Off : The
standby light is off
and no text
appears on Axcess’
display panel.
Axcess is
unplugged.
1. Plug Axcess in.
2. Press
POWER ON on the
remote, or POWER on
Axcess’ front panel. Axcess
will go through an auto-
matic network configura-
tion, which may include
automatically downloading
updated software from
Entré.
Do not press
any buttons on
either Axcess’
front panel or
remote control
until the
configuration
process is
complete.
Initializing : The
Standby light turns
off after illuminat-
ing briefly.
Axcess is
initializing
(starting up).
Press POWER ON on the remote,
or POWER on Axcess’ front
panel.
Standby : The
Standby light is
solid red.
Axcess is plugged
in, but not in use.
Press POWER ON on the remote,
or POWER on Axcess’ front panel
to begin using Axcess.
Power On : The
display panel
shows text and the
Standby light is off.
Axcess is
powered and
running.
Press POWER OFF on the remote,
or POWER on Axcess’ front panel
to return the system to standby.