Kodak 9020 - Manual (Page 4)

21
Electrical Approvals
The KODAK EKTAPRO 3020/4020/5020/7020/9020 Slide Projec-
tor complies with International Safety requirements and bears the
following safety marks:
• UL (Underwriter Laboratories Inc.)
• CSA (Canadian Standards Association)
• VDE (Verband Deutscher Elektrotechniker)
CE Conformity Mark
To show compliance with EMV-Directive 89/336/EEC and product
safety requirements, the slide projector bears the CE mark.
EKTAPRO 3020
In case of extreme mains disturbances problems with lamp flashing and/or
jamming may occur. In this case please switch the projector off and on again!
In case of a jam, please refer also to „Possible problems during operation as
written in the manual on page 34. (Please keep the tray position in mind
before switching on the projector. With the random access function of the
IR remote control or the rapid search via the reverse transport button you
will easily come back to this position.)
EKTAPRO 4020, 5020, 7020, 9020
The projector is correspondingly programmed to prevent it from becoming
uncontrollable in the case of severe mains disturbances. Should such
disturbances occur, the projector resets itself, i.e. it brings the tray into zero
position and resynchronises itself. It is then fully operative again and ready
for use.
Radio interference:
EEC directive 89/336
Australia standards AS 1044
RFS49 ISSUES July 1989
VCCI Regulations Nov. 1987 Class 2
Part 15 of FCC Rules Subpart J Class B
Canadian DOC C 108,8 -M 1983 Class B
Note: This digital apparatus does not exceed the Class B limits for radio noise
emissions from digital apparatus set out in the Radio Interference regulations
of the Canadian Department of Communications.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technican for help.
Electrical Approvals and
Conformity Mark
english