Kenwood KXF-W6010 - Manual (Page 18)

CT-2050/203/KXF-W6010/W4010 (En/M)
18
How to record (CT-203/KXF-W4010; Deck B only)
÷ If there is no recorded tune before, the tape will be rewound then
stopped.
÷ When re-recording from the beginning of tape, feed the leader tape (the
first portion of tape that cannot be recorded) before starting re-
recording.
To stop recording
To start recording again from the biginning
In stop mode During recording
Pause
To pause recording temporarily
How to provide non-recorded blanks between programs
The following procedure is useful when you want to cancel recording in progress and re-start it.
A non-recorded space of about 4 seconds or more should be reserved before the position where recording was started.
Press successively twice.
To resume recording
Press once.
÷ A non-recorded space of about 4 seconds is reserved on tape, then the
tape transport stops.
Blank of 4 sec. or more.
Recorded tune Tune to be re-recorded.
Tape stops after 2 sec.
of transport.
During recording in the 2 direction:
During recording in the 3 direction:
÷ When the ¡ (or 1) key is pressed during recording, recording is
aborted and tape is rewound as shown below if there is a non-recorded
space of more than 4 seconds before the recording start position.
÷ Recording starts.
÷ After leaving a non-recorded blank of about 4 seconds, the deck enters
the record-pause mode.
÷ The 8 indicator lights.
8
PAUSE
¶
REC/ARM
2 Stop playing the source component.
2 3 7
¶
REC/ARM
¶
REC/ARM
1
Rewind during recording.
2
Press the REC/ARM ( ¶) key twice.
3
Replay the tune you wish to record.
4
Press the REC/ARM ( ¶) key once.
¡ 1
¡ 1
¶
REC/ARM
¶
REC/ARM
CT-2050/KXF-W6010
CT-203/KXF-W4010
Re-recording
CT-2050/KXF-W6010
CT-203/KXF-W4010
1 Stop the tape transport.