Audio adjustments, Audio setup, Speaker setting – Kenwood eXcelon KDC-X792 User Manual
Page 24
24
|
KDC-X792/KDC-X692/KDC-MP738U/KDC-MP638U
Audio Adjustments
Audio Setup
You can set Sound system , such as follows;
Adjustment Item Display
Range
Front High Pass Filter “HPF-F”
Through/40*
1
/ 60*
1
/80/100/
120/150/180/220*
1
Hz
Rear High Pass Filter “HPF-R”
Through/40*
1
/ 60*
1
/80/100/
120/150/180/220*
1
Hz
Low Pass Filter
“LPF”
50*
1
/60/80/100*
1
/120/
Through Hz
Subwoofer Phase
“SW PHASE”
Reverse (180°)/ Normal (0°)
Volume offset
“VOL-OFFSET”
–8 — ±0 (AUX: -8— +8)
Loudness
“LOUD”
OFF/ON
Dual Zone System
“2 ZONE”
OFF/ON
*
1
KDC-X792/X692 only.
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “Zone2” of
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by
(page 23) or [
5]/[∞] button on the remote control
(page 28).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
For how to select source item, refer to
4).
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
Display
OFF
“OFF”
For 5 & 4 in. speaker
“5/4inch”
For 6 & 6x9 in. speaker
“6x9/6inch”
For the OEM speaker
“O.E.M.”
1
Enter Standby
Select the “STANDBY” display.
For how to select source item, refer to
4).
2
Enter Speaker Setting mode
Press the [AUD] knob.
“SP SEL” is displayed.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.