Konica Minolta DiMAGE E203 - Manual (Page 12)

12
GETTING UP AND RUNNING
INSTALLING AND REMOVING A MEMORY CARD
Insert the memory card all the way into the card slot and
then release(2). The card should catch in the slot.
• Insert the card so the face is toward the front of the
camera. Always push the card in straight, never at an
angle. Never force the card. If the card does not fit,
check that it is orientated correctly.
• If a MultiMediaCard is inserted incorrectly, it will lock,
but the card chamber door will not close.
To eject a memory card, press the card into the slot and
release (3). The card can now be pulled out.
Always turn off the camera and confirm the access lamp is
not lit before inserting or removing a memory card,
otherwise the card may be damaged, and data lost.
BATTERY
CARD
BATTERY
CARD
1
2
3
4
Close the battery-chamber door and slide it up (4) to engage the safety
catch.
Open the battery-chamber door by sliding the door down
(1) to release the safety catch; the door should spring
open.
ATTACHING THE HAND STRAP
Pass the small loop through the strap eyelet on the
body (1).
Pass the other end of the strap through the small
loop and tighten (2).
Always keep the strap around your wrist in the event
that the camera is accidentally dropped.
1
2
Access lamp
An SD (Secure Digital) Memory card or MultiMediaCard must be inserted for the camera to operate.
If a card has not been inserted, three zeros (000) will blink on the data-panel frame counter. For
more about memory cards, see page 7.