Settings apply only in p, a, s, m, and c modes, Using the, Using the jog dial to change p, a, s, m, or – Kodak DX7440 User Manual
Page 20: Using the jog dial to change, Using the jog dial to change p, a, s, m
Taking pictures and videos
14
www.kodak.com/go/support
Settings apply only in P, A, S, M, and C modes
Settings you change in P, A, S, or M modes apply only to pictures taken in P,
A, S, and M modes. Settings you change in C mode apply only to pictures
taken in C mode.
For example, if you change the Color Mode to Sepia while in P, A, S, or M
mode, then Auto & Scene modes retain the default setting of Color.
NOTE: The settings, including Flash, are maintained for P, A, S, M, and C modes—even when
you change modes or turn off the camera. Use Reset to Default (see
) to reset P, A,
S, M, or C mode to its default setting.
Using the jog dial to change P, A, S, M, or C mode settings
1 Turn the Mode dial to P, A, S, M, or C.
The mode settings are displayed. Available settings are white; unavailable
settings are grey.
2 Use the jog dial:
■
Rotate the jog dial
to move the cursor to a setting, such as
.
■
Press the jog dial to open the setting.
■
Rotate the jog dial
to change the value of the setting.
.
(Red settings are out of range and may cause unacceptable image/print
quality. Adjust the value higher or lower until it turns yellow.)
■
Press the jog dial to save the setting.
3 Press the Menu button to change other settings. (See
4 Take a picture.
the cursor or
Rotate to move
change settings.
Press to open or
save settings.
Jog dial