Cleaning the feed module tires, Cleaning the background strip(s), Cleaning the imaging guides – Kodak I3200 User Manual
Page 31
A-61771 March 2013
5-5
Cleaning the feed module
tires
10. Clean the feed module tires by manually rotating and wiping the feed
module tires with a roller cleaning pad. For best results wipe parallel to the
ribs in order to remove any residue between the ribs. You do not need to
remove the feed module to clean the tires.
11. Inspect the tires. If the tires show signs of wear or damage, replace the
feed module tires or the feed module. See “Replacement procedures” later
in this chapter.
Cleaning the background
strip(s)
12. Wipe the upper and lower background strips with a Staticide wipe.
13. Wipe the upper and lower background strips again with an almost-dry
Staticide wipe to remove any streaks.
Cleaning the imaging
guides
14. Wipe the upper and lower imaging guides with a Staticide wipe.
15. Wipe the upper and lower imaging guides again with an almost-dry
Staticide wipe to remove any streaks.
16. Close the scanner cover.
17. When finished with all cleaning procedures, turn on the scanner.