Konica Minolta IP-411 - Manual (Page 23)

2-6 Printer Drivers
Printer Drivers
Printing Modes
Real Time Mode Print
The print controller performs page printing and starts printing as soon as it starts receiving a print job. This
is different from document printing, where a printer starts printing only after receiving the entire print job.
Dual Access
The Dual Access function provides an efficient means for the printer to simultaneously handle different
types of printer/copier jobs. Dual Access capabilities are shown below:
• Scanning-Printing
• Printing - Copying
• Printing - Printing
• Copying- Copying
• Copying - Printing
The Electronic Recirculating Document Handler (E-RDH) allows the print engine to receive a job while it
is printing your scanned or stored documents.
The print engine controls and creates the messages on the operation panel screen. The operation panel
screen generates a Job Status screen, which is a copier type tab-based screen.
When you access printer setting values and parameters, the print controller will take over the control of the
operation panel screen.
Image Density Selection
Controlling the Print Density level provides an efficient way to save toner. You may select this function
directly from your print driver screen.
There are five distinct Print Density modes that can be used. Each mode is listed below, along with the
corresponding level of toner density used by the mode.
• Normal 100%
• Toner Save Mode 80%
• Draft Mode 60%