Kenwood KDC-MPV622 User Manual
Page 33
— 33 —
■ Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section
34) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
4
Tighten the screws (ш2 Ч 4 mm) (Accessory
6
) in the holes
shown on the diagram.
Accessory7
5
Tighten the screws (ш2 Ч 6 mm) (Accessory
7
) in the holes
shown on the diagram.
Accessory6
3
Tighten the screws (ш2.6 Ч 12 mm) (Accessory
5
) in the holes
shown on the diagram.
Accessory5
KDC-X569_U.S r2 02.10.31 10:09 AM Page 33
This manual is related to the following products: