Kenwood KDC-MPV622 User Manual
Page 10
switch as shown below.
4
Adjust the Audio item
Press the [
4] or [¢] button.
Adjustment Item
Display
Range
Bass Center Frequency* "Bass F"
60/70/80/100 or 150
Hz
Bass level
"Bass"/ "BAS"
–8 — +8
Bass Q Factor*
"Bass Q"
1.00/1.25/1.50/2.00
Bass Extend*
"Bass EXT"
ON/OFF
Middle Center
"MID F"
0.5/1.0/1.5/2.0 kHz
Frequency*
Middle level
"Middle"/ "MID"
–8 — +8
Middle Q Factor*
"Middle Q"
1.0/2.0
Treble Center Frequency* "TRE F"
10.0/12.5/15.0/17.5
kHz
Treble level
"Treble"/ "TRE"
–8 — +8
Balance
"Balance"/ "BAL"
Left 15 — Right 15
Fader
"Fader"/ "FAD"
Rear 15 — Front 15
Non-Fading level**
"NF Level"
–15 — +15
Front High Pass Filter*
"HPF F"
Through/100/125/
170 Hz
Rear High Pass Filter*
"HPF R"
Through/200 Hz
Front/Rear High Pass
"HPF"
Through/100/125/
Filter***
170 Hz
Non-Fading
"LPF NF"
50/80/120/Through
Low Pass Filter**
Hz
Volume offset
"V-Offset"/ "V-OFF" –8 — ±0
Loudness
"LOUD"
ON/OFF
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
Bass Center Frequency
1.00/1.25/1.50
60/70/80/100
2.00
60/70/80/150
1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
Audio Control
You can recall the best sound setting preset for different types of
music.
1
Select the source to set
Press the [SRC] button.
2
Select the Sound type
Press the [System Q] button.
Each time the button is pressed the sound setting switches.
Sound setting
Display
Flat
"Flat"/ "FLAT"
User memory
"User"/ "USER"
Rock
"Rock"/ "ROCK"
Pops
"Pops"/ "POPS"
Easy
"Easy"/ "EASY"
Top 40
"Top40"/ "TOP40"
Jazz
"Jazz"/ "JAZZ"
• User memory: The values set on the
11).
First, select the speaker type with the Speaker setting.
System Q
General features
— 10 —
English
KDC-X569_U.S r2 02.10.31 10:09 AM Page 10