Kenwood KDV-Z940 - Manual (Page 22)

— 22 —
English
Adjust the phase for Non-Fading output.
Display and setting:
"NF Phase" : Normal (0°) / Reverse (180°)
This mode is available only when the non-fading output function
is set to on.
NOTE
4.Phase for Non-Fading Output
Adjust the frequency of the High-pass filter for rear output.
Display and setting:
"REAR HPF" : THROUGH / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz
/ 150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter does not affect the
non-fading preout.
NOTE
2.High-pass Filter Frequency for Rear Output
Adjust the frequency of the Low-pass filter for Non-Fading
output.
Display and setting:
"NF LPF" : 50 Hz / 80 Hz / 120 Hz / THROUGH
This mode is available only when the non-fading output function
is set to on.
NOTE
3.Low-pass Filter Frequency for Non-Fading Output
Audio effect control features
You get a 3-D stereo effect when the Spatializer® function is
turned ON.
Hold down the 3-D button for one second or more to enter the
3-D stereo control mode.
The Spatializer® function is turned on.
Selecting mode
Each time you press the 3-D button to switch the Spatializer®
function as follows:
" BYPASS " / " LOW " / " MID " / " HIGH "
Press the 3-D button for one second or more to end the 3-D
stereo control mode.
If you make no button operation for 10 seconds, the 3-D stereo
control mode is automatically canceled.
Turning the Spatializer® function Off:
Select the "BYPASS" mode.
Press the 3-D button for one second or more. 2
1
NOTE
3
2
1
Spatializer® Function Setting: