Kenwood KDC-MP5032 - Manual (Page 31)

English | 31
Connecting Wires to Terminals
ANT.
CONT
MUTE
P.CONT
FR
ONT
L
FR
ONT
R
REAR
L
REAR
R
– +
SUB
WOOFER
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left speaker
To front right speaker
To rear right speaker
To rear left speaker
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key switch
Car fuse box
(Main fuse)
ACC
Car fuse box
Battery
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
Motor antenna control wire (Blue)
Dimmer control wire (Orange / White)
When using the optional power amplifier, connect to its
power control terminal.
To car light control switch
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
To connect the Kenwood navigation system, consult
your navigation manual.
TEL mute wire (Brown)
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To connect these leads, refer to the
relevant instruction manuals.
To Kenwood disc changer/
External optional accessory
Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
Sub Woofer left output
(White)
Sub Woofer right output
(Red)